Send to e-mail

Send to e-mail

A link for this product will be send to the Recipient. If You want to ask us a question about this product, please refer to the Contact section.

Recipient:* 
Your E-mail: 
Your name: 
Message: 


* Your name and E-mail will be show in message with link to product.

Very small and practical microcontroller with lots of features.

Features
• High Performance, Low Power AVR® 8-Bit Microcontroller
• Advanced RISC Architecture
– 120 Powerful Instructions – Most Single Clock Cycle Execution
– 32 x 8 General Purpose Working Registers
– Fully Static Operation
• Non-volatile Program and Data Memories
– 2/4/8K Bytes of In-System Programmable Program Memory Flash
• Endurance: 10,000 Write/Erase Cycles
– 128/256/512 Bytes In-System Programmable EEPROM
• Endurance: 100,000 Write/Erase Cycles
– 128/256/512 Bytes Internal SRAM
– Programming Lock for Self-Programming Flash Program and EEPROM Data Security
• Peripheral Features
– 8-bit Timer/Counter with Prescaler and Two PWM Channels
– 8-bit High Speed Timer/Counter with Separate Prescaler
• 2 High Frequency PWM Outputs with Separate Output Compare Registers
• Programmable Dead Time Generator
– USI – Universal Serial Interface with Start Condition Detector
– 10-bit ADC
• 4 Single Ended Channels
• 2 Differential ADC Channel Pairs with Programmable Gain (1x, 20x)
• Temperature Measurement
– Programmable Watchdog Timer with Separate On-chip Oscillator
– On-chip Analog Comparator
• Special Microcontroller Features
– debugWIRE On-chip Debug System
– In-System Programmable via SPI Port
– External and Internal Interrupt Sources
– Low Power Idle, ADC Noise Reduction, and Power-down Modes
– Enhanced Power-on Reset Circuit
– Programmable Brown-out Detection Circuit
– Internal Calibrated Oscillator
• I/O and Packages
– Six Programmable I/O Lines
– 8-pin PDIP, 8-pin SOIC, 20-pad QFN/MLF, and 8-pin TSSOP (only ATtiny45/V)
• Operating Voltage
– 1.8 - 5.5 V for ATtiny25V/45V/85V
– 2.7 - 5.5 V for ATtiny25/45/85
• Speed Grade
– ATtiny25V/45V/85V: 0 – 4 MHz @ 1.8 - 5.5 V, 0 - 10 MHz @ 2.7 - 5.5 V
– ATtiny25/45/85: 0 – 10 MHz @ 2.7 - 5.5 V, 0 - 20 MHz @ 4.5 - 5.5 V
• Industrial Temperature Range
• Low Power Consumption
– Active Mode:
• 1 MHz, 1.8 V: 300 µA
– Power-down Mode:
• 0.1 µA at 1.8 V

Contact form

Contact form

Name: 
E-mail: 
phone: 
Odesláním formuláře uděluji provozovateli webových stránek dobrovolný souhlas se zpracováním svých osobních údajů, které jsem ve formuláři uvedl. Tyto údaje mohou být použity výhradně pro komunikaci k tématu této zprávy a mohou být uchovány po dobu komunikace.

You might also be interested in

Universal printed circuit board 50mm x 70mm Arduino development Board

Universal printed circuit board 50mm x 70mm Arduino development Board
Hole pitch: 2.54 mm, Dimensions: 5 x 7 cm, Drilled holes: 1mm
Datasheets Heureka
 
In stock 125
0,48 tax incl. 0,40 tax excl.

Arduino ATMEGA328P-PU with bootloaderem

Arduino ATMEGA328P-PU with bootloaderem
ATMEGA328P-PU Microcontroller WITH ARDUINO UNO Bootloaderem Package content: 1 x ATMEGA328P-PU
 
In stock 22
5,00 tax incl. 4,13 tax excl.

Arduino 433 MHz transmitter + receiver

Arduino 433 MHz transmitter + receiver
The cheapest way to wirelessly transfer the data, included is the transmitter and the receiver
Tutorials Datasheets Heureka
 
In stock 43
1,91 tax incl. 1,58 tax excl.

DuPont 40Pin 2.54 mm pin strip straight

DuPont 40Pin 2.54 mm pin strip straight
1. Pitch 2.54 mm 2. connector: male 3, number of pins: 40Pin 4, type of row: Single-Row 5, connector type
Heureka
 
In stock 34
0,22 tax incl. 0,18 tax excl.

Transistor NPN BC547 45V

Transistor NPN BC547 45V
Collector-Emitter Volt (Vceo): 45V Collector Current (Ic): 0.1 And hfe: 110-800 @ 2mA Power Dissipation
 
In stock 121
0,09 tax incl. 0,07 tax excl.

Watch for availability